![]() Rectangle (1 coordinate, left, top, width-height) – similar to the previous setting, except that the upper left corner, width and height from the specified coordinate are used.In this case, the size after the operation will be the same for all images. Rectangle (2 coordinates: left-right, top-bottom) – the upper left and lower right coordinates are specified in pixels, counting from the upper left corner.In this case, cropping does not depend on the size of the image itself. This mode is suitable if you know the exact margin value. Margins – for proper cropping, specify the width of each margin separately.Crop – changes the image dimensions by cropping them.Not all images have the ability to write DPI value inside the file, and in this case, this parameter is ignored. ![]() The DPI parameter (dots per inch) does not change the pixel size of the images but is used to specify image resolution, linking the inches and pixels together.Usually, the size you specify will apply on the long side, and on the short side, the size will be smaller. When it’s on, the image will keep the original aspect ratio of the source image. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |